The most requested electrical services in Denton County are panel upgrades (especially in Denton, Lewisville, and Corinth homes built before 2005), EV charger installations (highest demand in Flower Mound, Highland Village, and Trophy Club), lighting upgrades (recessed LED conversions across all cities), and GFCI outlet installations (required in kitchens, bathrooms, garages, and outdoor locations for any home built before current code).

Outlet installations run $150 to $400 depending on complexity. Ceiling fan installations range from $200 to $500. GFCI outlet replacements cost $150 to $300 per location. Recessed lighting is $200 to $350 per fixture including the cut, housing, and wiring. Beachy Electric uses flat-rate pricing for standard services so you know the cost before work begins — no hourly surprises.

Yes. Landscape lighting for Lewisville Lake properties in Little Elm, The Colony, and Highland Village requires weatherproof outdoor-rated fixtures, properly buried conduit or direct-burial cable, GFCI-protected circuits, and a dedicated transformer sized for the full lighting load. We design the lighting layout, install the wiring and fixtures, and connect everything to a timer or smart control system for automated scheduling.

Yes. New homes in Aubrey and Little Elm often need electrical services that builders did not include — dedicated home office circuits, USB outlets throughout the house, ceiling fan activations where only a junction box was roughed in, garage workshop power (240V for welders and compressors), outdoor kitchen circuits, and EV charger installations. These are the most common add-on services for homes less than two years old.

Whole-home surge protection is a device installed at your main electrical panel that absorbs voltage spikes before they reach your appliances, electronics, and HVAC equipment. Denton County sits in North Texas’s severe storm corridor — spring hail and lightning activity along the I-35 and Lewisville Lake corridors causes power surges that destroy TVs, computers, refrigerators, and smart home systems. A panel-mount surge protector costs $300 to $600 installed and can prevent thousands in equipment damage.

Yes. A dedicated 240V circuit for a dryer, welder, compressor, or EV charger requires running properly sized wire from your panel to the outlet location, installing a double-pole breaker, and mounting the correct receptacle type for your equipment. Beachy Electric verifies your panel has available slots and sufficient amperage capacity before running the new circuit. This service is common in Aubrey, Sanger, and Argyle homes where homeowners set up workshops in detached garages and outbuildings.

Yes. Smart switch installation requires a neutral wire in the switch box — something many Denton County homes built before 2011 lack. Beachy Electric verifies neutral wire presence, runs one if needed, and installs smart switches, dimmers, and fan controllers compatible with your chosen platform (Alexa, Google Home, Apple HomeKit). For full automation, we pre-wire rooms with Cat6 and low-voltage cabling for Lutron, Savant, or Control4 systems.

Call Beachy Electric at 469-283-1089 or contact us to book online. Describe the service you need — outlet install, lighting upgrade, panel check, EV charger, ceiling fan, or anything else — and provide your Denton County city. We schedule your free assessment, often same-day or next-day for most locations between The Colony and Denton.